您好,欢迎访问安平县华耀智慧农业科技有限公司!
华耀农业设施工程有限公司
热门产品:
新闻中心
当前位置:网站***页 > 新闻中心

安平县华耀苗床厂_移动苗床_苗床网片_厂家批发价格

安平县华耀苗床厂_移动苗床_苗床网片_厂家批发价格

       苗床顾名思义就是用来放苗的床,其分为固定苗床和可移动苗床。固定苗床就是苗床固定在了种植温室地面上,床面不可移动。手摇式移动苗床就是床面可以移动的床。由于固定苗床的土地利用率较低,因此逐渐被手摇式苗床所取代。
那么问题来了为什么要使用手摇式移动苗床呢?为什么不直接把盆花放在地上呢。
 
1、苗床网的高度大约在0.6米高,加上盆花自有高度在一米左右,正好工人站着很自然的工作,不会很累。
 
2、苗床网将植物镂空太高,形成上下的通风空间、不宜滋生细菌等。
 
3、由于大面积生产温室一般都会安装喷灌或者自走式水车来代替人工浇水,如果植物直接放在地下会长期泡在水中,容易导致根部腐烂。
 
4、移动式苗床土地利用率高,温室跨度为8米,可以放4个1.8米也就是苗床实际是7.2米,温室土地利用率为90%。

如何养好红掌

1. 红掌生长适宜温度为18摄氏度-28摄氏度,温度太低容易发生冻害。如果所在环境中冬天没有霜冻,红掌基本不会死。温度太高,红掌能量消耗太大,佛焰苞容易褪色,所以夏季注意保持通风降温,多喷水。
2.  由于红掌原产地特性,决定了红掌生长需要较高的空气湿度。一般大棚养植培育过程中会将空气湿度维持在百分之六十到百分之八十之间,想必家庭养护过程中则比较难达到这样的条件,这个时候可以采用喷雾,加湿器来增加叶面和室内空气相对湿度,从而创造适宜红掌生长的环境,如果有条件,将红掌放在热带雨林缸中养,那是再好不过哦。
3. 良好的光照是红掌进行光合作用的必要因素,对它的叶色、花、佛焰苞的品质会有重要影响。室内养红掌需要一定的散射光,可以放在卧室靠窗台处,客厅明亮有散射光的地方等。夏天光照过强,建议不要放在室外直晒,否则可能造成叶片变色、灼伤或者焦枯的现象,到时后果不堪设想。
4.  红掌喜欢湿润的环境,不要等它的基质都干透了才知道浇水,一般在盆土微干时就可以进行浇水了,记得始终保持土壤是湿润的状态,自来水不建议使用。
5. 如需施肥,可选择高磷钾肥,能促进开花,结合浇水一起使用。一次性不能施肥太多,薄肥勤施***好。
6. 红掌的基质选择疏松透气的粗泥炭混合细泥炭,粗细比例1:1左右比较合适,再混合少量整株岩。如果是刚买回来的红掌建议不要立即换盆种植,***好是等植株长大,根系长满后再换大盆养。

育苗移动苗床-生态蔬菜育苗移动苗床的规格:
苗床设计宽度1.4m,长度38m,高度0.75m,每跨设4组,总计24组
苗床立柱、横梁采用40×30×1.5mm的矩形管,床面四周采用铝合金边沿,网片所有材料都采用热镀锌处理。
材质:优质低碳钢丝
丝径:4.0mm /3.0mm
网孔:120 mm×25mm 130mm×30mm 50mm×50mm
尺寸:1.9m×4m


Anping Huayao seedbed factory_ Moving seedbed_ Seedbed mesh_ Wholesale price of manufacturer
 
As the name implies, seedbed is used to put seedlings, which is divided into fixed seedbed and movable seedbed. Fixed seedbed means that the seedbed is fixed on the ground of planting greenhouse, and the bed surface cannot be moved. Manual moving seedbed is the bed with movable surface. Due to the low land use efficiency of fixed seedbed, it is gradually replaced by hand-held seedbed.
 
So the question is, why use a mobile seedbed? Why not just put the potted flowers on the ground.
1. The height of the seedbed net is about 0.6 meters high, and the height of potted flowers is about 1 meter. It is just that the workers are standing very naturally and will not be very tired.
2. The seedling bed net hollows out the plants too high, forming a ventilation space above and below, and not suitable for breeding bacteria.
3. Due to the large-scale production greenhouse will generally install sprinkler irrigation or self-propelled water truck instead of manual watering. If plants are directly placed underground, they will soak in water for a long time, which is easy to cause root rot.
4. The mobile seedbed has a high land utilization rate. The greenhouse span is 8 meters, and 4 1.8 meters can be placed. That is to say, the actual seedbed is 7.2 meters. The land utilization rate of greenhouse is 90%.
 
How to raise Anthurium andraeanum?
 
1. The suitable temperature for Anthurium andraeanum growth is 18 ℃ - 28 ℃. If the temperature is too low, it is easy to cause freezing damage. If there is no frost in winter, Anthurium andraeanum will not die. If the temperature is too high, the energy consumption of Anthurium andraeanum is too high, and the spathe is easy to fade, so pay attention to keep ventilation and cool down in summer and spray more water.
 
2. Because of the origin characteristics of Anthurium andraeanum, the growth of Anthurium andraeanum needs higher air humidity. In general greenhouse cultivation, air humidity will be maintained between sixty percent and eighty percent. It is difficult to achieve such conditions in the process of family maintenance. At this time, spray and humidifier can be used to increase the relative humidity of the leaf and indoor air, so as to create suitable environment for the growth of Anthurium. If conditions permit, the Anthurium should be placed in the tropical rain forest tank. That would be great.
 
3. Good illumination is a necessary factor for photosynthesis of Anthurium andraeanum, which has an important influence on the leaf color, flower and spathe quality. Indoor cultivation of Anthurium andraeanum needs a certain amount of scattered light, which can be placed in the bedroom by the windowsill, and the living room where there are scattered light. If the light is too strong in summer, it is recommended not to put it in the direct sunlight outdoors, otherwise it may cause discoloration, burn or scorch of the leaves, and the consequences will be unimaginable.
 
4. Anthurium andraeanum likes humid environment. Don't wait for its substrate to be dry before watering. Generally, watering can be carried out when the basin soil is slightly dry. Remember to keep the soil moist all the time. Tap water is not recommended.
 
5. If fertilization is needed, high phosphorus and potassium fertilizer can be selected, which can promote flowering and be used together with watering. It is better to apply thin fertilizer frequently.
 
6. The matrix of Anthurium andraeanum is composed of loose and breathable coarse peat mixed with fine peat, and the ratio of coarse peat to fine peat is about 1:1, and then a small amount of whole plant rock is mixed. If it is a newly bought Anthurium andraeanum, it is recommended not to plant it in pots immediately. It is best to wait for the plants to grow and the roots to grow up.

Mobile seedbed for seedling raising - Specifications of mobile seedbed for ecological vegetable seedling raising:
 
The design width of the seedbed is 1.4m, the length is 38m and the height is 0.75m. There are 4 groups in each span, with a total of 24 groups
 
The column and crossbeam of seedbed are made of 40 × 30 × 1.5mm rectangular tubes. The edge of aluminum alloy is used around the bed surface. All materials of mesh are hot-dip galvanized.
 
Material: high quality low carbon steel wire
 
Wire diameter: 4.0 mm / 3.0 mm
 
Mesh: 120 mm × 25 mm 130 mm × 30 mm 50 mm × 50 mm
 
Size: 1.9m × 4m



 

版权所有 安平县华耀智慧农业科技有限公司 联系人:张女士 电话:18503185891 Q Q:3059217513 微信:18503185891 网址:www.huayaomiaochuang.com 地址:河北省衡水市安平县 冀ICP备19015047号-2

微信二维码